Front Panel Displays Table 23-1

MENU	/DEV	/MAX	DESCRIPTION
INPT	Show input choices	RTD 2. RTD 3. RTD.4	INPUT TYPE 2-wire RTD 3-wire RTD 4-wire RTD
DEC.P	Show input choices	FFFF. FFF.F	DECIMAL POINT
RD.CF	R.1	F C	READING CONFIGURATION Display in░F Display in ░C
S1.CF	S.1= S.2=	A B U L	SETPOINT 1 CONFIGURATION: A: Active above B: Active below U: Unlatched L: Latched
S2.CF	S.1= S.2=	A B U L	SETPOINT 2 CONFIGURATION: A: Active above B: Active below U: Unlatched L: Latched
S1.DB	Scroll right one digit	Change the flashing digit's value	SETPOINT 1 DEADBAND Select from 0000 through 9999 (Factory preset: 0003).
S2.DB	Scroll right one digit	Change the flashing digit's value	SETPOINT 2 DEADBAND Select from 0000 through 9999 (Factory preset: 0003).
OT.CF	0.1 0.2 0.3 0.4 0.5	D E V C O P D R F H	OUTPUT CONFIGURATION Analog Output: D: Disabled E: Enabled V: Voltage analog out C: Current analog out O: Proportional to reading P: Proportional to Setpoint 1 D: Direct reading R: Reverse acting F: 0-10 V proportional H: 0-5 V proportional
Note: If you select 0.2 = V, you may select your analog output to be 0-10 V or 0-5 V by accessing submenu 0.5. If you select 0.3=P, you may select your proportional output analog to be direct or reverse acting (4-20 or 20-4).
OT.S.O Enter new value and show: OUT1. Enter new value and show: RD 2. Enter new value and show OUT2.	Show RD 1 and prior value entered. Scroll right one digit Prior value entered. Scroll right one digit Prior value entered. Scroll right one digit	Change the flashing digit's value Change the flashing digit's value Change the flashing digit's value	OUTPUT SCALE AND OFFSET
P.BND	Scroll right one digit	Change the flashing digit's value	PROPORTIONAL BAND Select from 0000 through 9999
M.RST	Scroll right one digit	Change the flashing digit's value	MANUAL RESET Select from -1999 through 9999

MENU	/DEV	/MAX	RESET	DESCRIPTION
PEAK		Shows the peak reading and must be pressed again to return to the normal operating mode without resetting.	Reset the peak reading when in this mode.	Peak Reading Shows the highest reading since last reset.
SP.RS				LATCHED RESET Pressing the RESET button will reset your setpoints.
DEV	Shows the difference between the display reading and the setpoint 1 value.		Tunes the propor-tional control if 0.3=P. Goes back to "run" mode if 0.3=A

Setpoint Configuration Displays Table 24-1

MENU	/DEV	/MAX	DESCRIPTION
SP1	Scroll right one digit	Change the flashing digitÆs value	SETPOINT 1 Select from -1999 through 9999
SP2	Scroll right one digit	Change the flashing digitÆs value	SETPOINT 2 Select from -1999 through 9999